Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

7. Used for accessory components.

Removal

Remove the marked part.

Remove the screw.

Tightening torque: Seat belt guide, to Bracket , 4.4 Nm

Release the catch.

Remove the marked part.

Remove the screw.

Tightening torque: Cargo anchor, to body , 13 Nm

Remove the marked part.

Repeat on the other side.

Remove the screw.

Tightening torque: Cargo anchor, to body , 13 Nm

Repeat on the other side.

Remove the marked part.

Vehicles with keyless entry

All vehicles

Remove the screws.

Remove the marked part.

Disconnect the connectors.

Remove the panel.

Accessory installation

Clean the surface.

Use: 1161721, Isopropanol

Install component that comes with the accessory kit.

When installing Velcro tape the surface must maintain a temperature of at least +20 ° C (68°F).

Clean the surface.

Use: 1161721, Isopropanol

Install component that comes with the accessory kit.

Install the marked component.

Position/route the cables as illustrated.

Install the cables.

Use a cable tie

Vehicles with towbar

Disconnect the connector.

Connect the connector.

Connect the connector.

Vehicles without tow hitch.

Locate the pre-routed connectors.

Connect the connector.

Secure the connectors.

Use a cable tie

All vehicles

Remove the marked part.

Remove the nut.

Fold marked part aside.

Release the catches.

Fold marked part aside.

Fold marked part aside.

Remove the marked part.

Connect the cable.

Position/route the cable as illustrated.

Install the cable.

Use a cable tie

Reinstall the removed part.

Reinstall the removed part.

Install components that come with the accessory kit.

Remove the nut.

Connect the prerouted cable.

Install the nut.

Tightening torque: M6 , 10 Nm

Installation

Reinstall the removed parts in reverse order.