Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

1. Remove the screws.

2. Remove the clips.

The part is not to be reused.

Remove the panel.

The part is not to be reused.

Accessory installation

Drill the holes.

Use special tool: T9814112, Drill

Drill the holes.

Use: , Rust inhibitor, low viscosity

Use special tool: T9512782, Rivet nut tool

Reset the tool.

Use hands only.

The outermost thread of the tool should be flush with the rivet nut end.

Press the tool against the surface.

Hold the tool at right angles to the surface.

Tighten to the value stated.

Measure

Use: Vernier caliper

Install components that come with the accessory kit.

Repeat on the other side.

Install components that come with the accessory kit.

Use the black screws.

Repeat on the other side.

Install the screws.

Tighten the bolts.

Tightening torque: M10 , 50 Nm

Tighten the bolts.

Tightening torque: M10 , 50 Nm