2011 L.H.D

Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
S80 2011
S80 (07-) 2011

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
313460801.031407107, 31350479
Towbar, control module (TRM)




Equipment
IMG-242205
IMG-345497
IMG-332314

IMG-361617


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 
1
IMG-245980
 

  • Set the ignition key to position 0.


    Note!

    Wait at least one minute before unplugging the connectors or removing other electrical equipment.


2
IMG-226720
 

  • Lift out the cargo compartment carpet.

3
IMG-226722
 

  • Remove the sill trim panel by first pulling it forward until the two clips in the front edge release. Then pull it upward until the two clips in the top edge release.

4
IMG-226723
 

  • Fold the left-hand rear seat backrest forward.

5
IMG-226724
 

    Remove:

  • the three clips in the top edge of the side panel

  • the four plastic nuts in the lower edge of the side panel

  • the connector to the cargo compartment lighting

  • Lift out the side panel.

6
IMG-360485
 

  • Use: Isopropanol, 1161721.

    Wipe dry.

7
IMG-360486
 

  • Use: Isopropanol, 1161721.

    Wipe dry.

8
IMG-356181
 

9
IMG-222282
 

10
IMG-241925
 

11
IMG-360498
 

When installing Velcro tape the surface must maintain a temperature of at least +20 °C (68° F).

12
IMG-360492
 

13
IMG-360501
 

When installing Velcro tape the surface must maintain a temperature of at least +20 °C (68° F).

  • Press the control module into place properly.

14
IMG-360526
 

Applies to cars with rear parking cameras

  • Unplug the connectors.

15
IMG-360527
 

  • Remove the control module. It is secured with a Velcro strip.

16
IMG-360528
 

  • Remove the Velcro strip on the reverse of the control module.

17
IMG-360529
 

  • Remove the Velcro strip.

18
IMG-360548
 

  • Remove adhesive residue and clean.

  • Use: Isopropanol, 1161721.

    Wipe dry.

19
IMG-360549
 

  • Use: Isopropanol, 1161721.

    Wipe dry.

20
IMG-361618
 

21
IMG-222282
 

22
IMG-241925
 

23
IMG-360550
 

When installing Velcro tape the surface must maintain a temperature of at least +20 °C (68° F).

24
IMG-360551
 

25
IMG-360552
 

When installing Velcro tape the surface must maintain a temperature of at least +20 °C (68° F).

  • Press the control module into place properly.

26
IMG-360486
 

  • Use: Isopropanol, 1161721.

    Wipe dry.

27
IMG-356181
 

28
IMG-222282
 

29
IMG-241925
 

30
IMG-360498
 

When installing Velcro tape the surface must maintain a temperature of at least +20 °C (68° F).

31
IMG-360492
 

32
IMG-360577
 

When installing Velcro tape the surface must maintain a temperature of at least +20 °C (68° F).

  • Press the control module into place properly.

33
IMG-360576
 

  • Connect the connectors to the control module.

34
IMG-360508
 

Applies to all models

  • Locate the connectors in the car's cable harness.

35
IMG-360521
 

  • Connect the connectors to the control module.

36
IMG-241926
 

Applies to vehicles with chassis numbers up to and including -122408

  • Press in the catches on the black cover on the fuse holder and remove it.

37
IMG-241927
 

  • Fit a 40A fuse in position FA11.

38
IMG-360159
 

Applies to vehicles with chassis numbers up to and including -122409

  • Press in the catches on the black cover on the fuse holder and remove it.

39
IMG-360188
 

  • Fit a 40A fuse in position FA11.

  • Reinstall the cover.

40
 

Applies to all models

  • Reinstall the detached components in reverse order.

41
IMG-242268
 

  • Download the software (application) for the accessory's function following the service information in VIDA.

    See VIDA or the accessories catalogue for software part number.