Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Remove the screws.

Remove the screws.

Remove the screws.

Request the aid of a colleague for this procedure.

Remove the screws.

Remove the screws.

Scrape off all sealant from the flat surface.

Clean the surface.

Repeat on the other side.

Accessory installation

Install the screws.

Repeat on the other side.

Use special tool: T9995972, FIXTURE (UNIVERSAL/TRANSAXLES)

Use special tool: T9985972, JACK (HYDRAULIC)

Repeat on the other side.

Repeat on the other side.

Use special tool: T9997338, Extension rod

Installation

Use: , Rust inhibitor, low viscosity

Repeat on the other side.

Removal

Locate relevant marking.

Deburr edges

Vehicles with Skidplate

Locate relevant marking.

Apply tape to the other side, opposite the marking lines.

Deburr edges

Vehicles with R-design

Locate relevant marking.

Deburr edges

Vehicles with Polestar Performance diffuser

Cut the component following the instructions in the graphic.

Deburr edges

All vehicles

Reinstall the removed parts in reverse order.