• Set the ignition key to position 0.

  
  

  Note! Wait at least one minute before unplugging the connectors or removing other electrical equipment.

  
  

• Lift out the cargo compartment carpet.

• Remove the sill trim panel by first pulling it forward until the two clips in the front edge release. Then pull it upward until the two clips in the top edge release.

• Fold the left-hand rear seat backrest forward.

Remove:

• the three clips in the top edge of the side panel

• the four plastic nuts in the lower edge of the side panel

• the connector to the cargo compartment lighting.

• Lift out the side panel.

• Take three screws and nuts from the kit and install the connector in the bracket.

• Remove the rubber grommet in the floor and place it to one side, it shall not be used again.

• Insert the cable with the connector into the hole in the spare wheel well and install the rubber grommet.

  
  

  Note! Install the rubber grommet so that the cable points to the left on the inside.

  
  

• Adapt the length of the cable from the connector to the rubber grommet so that the cable is not too slack beneath the car.

• Route the wiring following the existing cable harness in the car.

• Take the ground screw from the kit and secure the ground lead to the ground terminal in the rear crossmember.

  Torque tighten the screw, tightening torque: 10 Nm (7.5 lbf.ft.).

• Plug the green connector into the Trailer Module (TRM).

• Clamp up the cable harness at the existing cable harness using two tie straps from the kit.

Applies to vehicles with Chassis number up to and including -122408

• Remove the fuse holder in the cargo compartment. First press down the locking catches with a small screwdriver on the top and bottom, and then pull it out.

• Remove the cover on module 1. The cable must be connected and the fuse installed in fuse module 1, which has a black cover. Some vehicles are not equipped with module 3 and 4, but the connection must always be made in the module with a black cover.

• Connect the orange (OR) cable on the rear of fuse module 1, to fuse position 9 in the vacant socket.

• Take a 15A fuse from the kit and install it in position 9 in fuse module 1.

• Reinstall the fuse holders.

• Reinstall the cover.

Applies to vehicles with Chassis number from and including 122409-

• Remove the fuse holder in the cargo compartment. First press down the locking catches with a small screwdriver on the top and bottom, and then pull it out.

• Remove the cover.

• Connect the orange (OR) cable on the rear of the fuse module, to fuse position 4 in the vacant socket.

• Take a 15A fuse from the kit and install it in position 4 in fuse module.

• Reinstall the fuse holders.

• Reinstall the cover.

Applies to all models

• Checking the 13 pin connector.

Position - Function

1. Left-hand indicator

2. Rear fog lamps

3. Ground terminal

4. Right-hand indicator

5. Right parking lamps

6. Brake lamp

7. Left parking lamps

8. Reversing lamp

9. Battery voltage, constant

10. Battery voltage, ignition on

11. Ground terminal

12. Not connected.

13. Ground terminal

• Reinstall the detached components in reverse order.