Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
C30 2007

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
307402971.330789039, 30721695
Net pocket, side panel




IMG-248923




 
Equipment
A0000162
IMG-239940
IMG-239981

IMG-248924


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 
1
IMG-240957
 

2
IMG-248925
 

  • Apply a wide piece of tape to mark the rear hole for the net pocket.

3
IMG-248926
 

  • Press two clips into the rear end of the net pocket. The buttons (1) of the net pocket must be facing outwards.

4
IMG-248927
 

  • Place the rear end of the net pocket against the rear panel as illustrated.

  • Make marks through the holes in the clips and on the pieces of tape where the holes are to be. Use a pen.

5
IMG-241183
 

  • Remove the tailgate's sill panel by pulling it up until the four clips on the upper side and the eight catches at the lower edge release.

6
IMG-248928
 

  • Check on the reverse of the panel that there are no cables in the way where the holes are to be made.

  • Insert a scriber through the marked holes and press through the panel so that the holes are enlarged to approximately Ø4.8 mm (3/16"). Counterhold the reverse of the panel if necessary.

  • Remove the tape strip.

7
IMG-248929
 


Note!

Do not trap the net in the pop rivet when the clip is secured.


8
IMG-250863
 

9
IMG-248930
 

  • Press the two clips into the net pocket's front end.

10
IMG-248931
 

  • Position the clips as illustrated.

  • Position the net pocket against the side panel.

  • Insert a scriber through the holes in the clips and press through the panel so that the holes are enlarged to approximately Ø4.8 mm (3/16").

11
IMG-248932
 


Note!

Do not trap the net in the pop rivet when the clip is secured.


12
IMG-246796