Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Conditions

When installing, the car must retain a temperature of 20 degrees C.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Set the ignition key to position 0.

Turn the wheel inwards.

Remove the screws.

Clean the Bumper Cover surface.

Use: , soap solution

Use the template in the installation instructions.

Cut following the dotted lines.

Accessory installation

Secure the template with tape.

Adjust the hole with a file or knife as necessary.

Pull the wiring through.

Ground connection

Lubricate the O-ring.

Use: 1161761, Grease

Vehicles without passenger compartment connector

Install the clips as illustrated.

Vehicles with passenger compartment connector

Install the clips as illustrated.

1. Cable from Engine block heater

2. Cable from front socket

3. Passenger Compartment Connector Cable

All vehicles

Removal

Place a container under the car.

Drain the coolant.

Tighten the nipple after draining the coolant.

Remove the hose.

Reinstall the screw.

Tightening torque: M8 , 24 Nm

Tighten the hose clamps.

Install the screw.

Tightening torque: M6 , 10 Nm

Connect the prerouted cable.

Install the catch.

Installation

Reinstall the removed parts in reverse order.

Fill with coolant and run the engine to operating temperature.

Vent the cooling system and check for leakage.

Post-fill the cooling system if necessary.