Installing front mudguard

Installing front mudguard

• Turn the wheels to the left

• Clean the area at the rear edge of the wing liner where the mudguard will be positioned

• Remove the three screws holding the wing liner to the body. Place the screws to one side. New screws are supplied in the kit.

• Clean the marked surface at the rear edge of the front wing. Use a mixture of 30% windscreen washer fluid and 70% water. Wipe dry.

• Remove the backing from the masking tape

• Secure the masking tape at the front edge on the front wing. Position the tape just inside the curve of the front wing as illustrated

• Secure along the entire front edge first. Then securely press backwards. Puncture any air bubbles using a needle

• Press the masking tape into place firmly.

• Clean around the screw holes in the rear edge of the wing liner

• Take the mudguard, new screws and rivet from the kit. Tighten the mudguard to the wing liner and body

• Drill a hole through the upper hole in the mudguard and into the wing liner. Use a 5 mm (3/16”) diameter drill bit

• Remove any swarf

• Rivet the upper mounting of the mudguard to the wing liner

• Repeat the above points on the other side.

Installing rear mudguard

Installing rear mudguard

• Clean the area at the rear edge of the wing liner where the mudguard will be positioned

• Remove the four screws holding the wing liner to the bumper cover. Place the screws to one side. New screws are supplied in the kit.

• Clean around the screw holes in the rear edge of the wing liner

• Take the mudguard and the new screws from the kit. Tighten the mudguard to the wing liner and the bumper cover

• Repeat the above points on the other side.