Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
V70 2006
V70 (00-08) 2006

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
307375951.0
12V socket, cargo compartment




 
Equipment
A0000162
A0000163
A0000180

M3703739





 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 
1A
M8503004
1B
M8503188
 

Illustration A

  • Remove the rear floor hatch. Open the rear floor hatch and pull it straight backwards.

  • Place the floor hatch to one side.

  • Turn the knobs on the right and left-hand sides of the storage box. Lift out the storage box.

Illustration B

    Only applies to cars with an auxiliary rear facing seat

  • Fold up the auxiliary rear facing seat's seat cushion.

  • Turn the knobs on the right and left-hand sides of the trough. Lift out the trough.

2
M8503006
 

  • Remove the folding panel from the right-hand side in the cargo compartment.

3
M8503182
 

    Only applies to cars with an auxiliary rear facing seat

  • Remove the side floor hatch on the right-hand side by first prizing up one end with a plastic weatherstrip tool, and then pull the side floor hatch up.

4A
M8503008
4B
M8503183
 

Illustration A

  • Remove the right side panel by first removing the cover and the screw in the front edge.

  • Pull the top edge of the panel out until the clips release.

  • Fold the panel inwards. Lift the panel out.

Illustration B

    Only applies to cars with an auxiliary rear facing seat

  • Remove the side panel on the right-hand side by first removing the cover and screw in the front edge.

  • Pull the top edge of the panel out until the clips release.

  • Pull the seatbelt from the holder (1).

  • Remove the seatbelt cover (2) by bending away the catches on the underside and pulling the cover up.

  • Fold the panel inwards. Lift the panel out.

5
M8503049
 

  • Take the right side panel and drill out the hole for the 12V socket in the marking in the upper rear corner on the lower section of the panel.

  • Pre-drill the hole using a Ø3 mm (1/8") bit.

  • Drill out the hole using a Ø27 mm (1 1/16") diameter hole saw.

  • File out the hole with a round and square file.

6
M3903008
 

  • Install the 12V socket in the panel.

  • Fit the nut on the 12V socket on the rear side of the panel and tighten.

  • Identify the routed cable located by the right-hand floor support.

  • Plug in the connector.

7
M3903010
 

    Reinstall:

  • the side panel. Make sure that the cable to the 12V socket is not trapped when it is installed.

  • the folding hatch.

  • the storage box.

  • the rear floor hatch

    Only applies to cars with an auxiliary rear facing seat

  • Reinstall the side panel. Make sure that the cable to the 12V socket is not trapped when it is installed.

  • Reinstall the seatbelt cover.

  • Guide the seatbelt into its holder.

  • Reinstall the side floor hatch.

  • Reinstall the trough.

  • Fold back the auxiliary rear facing seat's seat cushion.