2009 L.H.D

Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
S80 2009
S80 (07-) 2009

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
313169271.331316926, 31266798
Power socket in cargo compartment




IMG-274363




Equipment
A0000162
IMG-239664
IMG-239660
IMG-239942
IMG-239681

IMG-350526


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

  

Note!

Some steps in these installation instructions are presented with illustration only.


 
1
IMG-245980
 

  • Turn the ignition key to position 0.


Note!

Wait at least three minutes before unplugging the connectors or removing other electrical equipment.


2
IMG-226720
 

3
IMG-226722
 

4
IMG-226721
 

  • Detach the rubber strip in the cargo compartment opening.

5A
IMG-274366
5B
IMG-274367
 

Illustration A

    Remove:

  • the three clips in the top edge of the side panel

  • the three plastic nuts in the lower edge of the side panel

  • the connector to the cargo compartment lighting.

Illustration B

  • Twist out the rear edge of the panel so that the marking for the hole is accessible.

 
6
IMG-274368
 

  • Carefully drill up the hole for the power outlet in the lower, rear corner of the panel. The placement of the hole is marked.

  • Pre-drill first using Ø3 mm (1/8") a bit.

  • The drill out the hole using a Ø27 mm (1 1/16") diameter hole saw.

  • File out the hole with a round and square file.

  • Remove any swarf.

7
IMG-284585
 

  • Take the electrical socket, spacer and nut from the kit.

  • Fit and tighten.

8
IMG-274370
 

Applies to vehicles with pre-routed cable to the power outlet.

  • Find the pre-routed cable with the 2-pin connector under the right-hand tail lamp.

9
IMG-274371
 

  • Connect the connector to the power outlet.

 
10A
IMG-265640
10B
IMG-265208
 

Applies to vehicles without a pre-routed cable to the power outlet.

Illustration A

    Remove:

  • the three clips in the top edge of the side panel.

  • the three rearplastic nuts at the rear edge of the side panel.

  • the connector to the cargo compartment lighting.

Illustration B

  • Twist out the panel to access the tail lamp.

11
IMG-274372
 

  • Take the cable harness out from the kit. Place it along the rear harness with the white connector (1) by the right-hand tail lamp.

12
IMG-343691
 

13
IMG-343692
 

14
IMG-343693
 

  • Install new fuse.

15
IMG-343694
 

16
IMG-265222
 

  • Connect the existing grey 2-pin male connector (1) to the grey 2-pin female connector (2) in the pre-routed cable harness.

  • Clamp the excess cable (3) and fuse (3) with cable ties from the kit.

  • Connect the ground lead to the existing ground terminal. Tighten the screw. Tighten to 10 Nm (7.5 lbf ft).

    Applies to cars with parking assistance camera (PAC)

  • Disconnect the gray male connector from the control module. Connect it to the 2-pin male connector on the cable harness. Connect the remaining connectors to the control module. Clamp the fuse and any excess cable as previously.

17
IMG-265217
 

  • Clamp the pre-routed cable harness at the existing cable harness with four cable ties from the kit.

    If there is no cable harness to secure to, tape up the new cable harness.

18
IMG-274371
 

  • Connect the connector to the power outlet.

 
19
IMG-274373
 

20
IMG-265225
 

21
IMG-226734
 

22
IMG-226735
 

23
IMG-284586
 

  • Open the cover of the rear fuse holder.

24
IMG-284587
 

  • Press in the catches at the sides of the fuse module RJB-A (black cover) and pull it out.

25
IMG-284590
 

  • Take the fuse from the kit and install it in position 11.

26
IMG-284592
 

27
IMG-284593
 

28
IMG-255793