Running board - XC60 2013 - Volvo Cars Accessories

Installation instructions, accessories

Volvo Car Corporation Gothenburg, Sweden

XC60 2013

XC60 (-17) 2013

Instruction No		Version		Part. No.
31214150		1.1		30784191

Running board

IMG-287283

Equipment

A0000162

IMG-287285

IMG-239664

IMG-287286

IMG-213320

INTRODUCTION

Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available before starting installation.
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Note!

Some steps in these installation instructions are presented with illustration only.

Preparations

IMG-245980

Preparations

Turn the ignition switch to position 0.

Note!

Wait at least three minutes before unplugging the connectors or removing other electrical equipment.

IMG-287287

IMG-285505

IMG-296643

IMG-296644

IMG-296645

Removal of rear door

Illustration A

Illustration B

Carefully depress the catch on the connector in the door and pull off.
Remove the screws for the door stop.

Illustration C

Remove the screws in the upper and lower hinge.

IMG-296646

Lift off the door with a colleague.
Place the door out of harms way.

IMG-287303

Removal of the sill panel.

Pull off the sill panel at the rear edge, it is secured by six clips.

IMG-287304

Detach the rubber strip from the panel up to the front of the seven clips.

IMG-287306

Insert a small flat head screwdriver in the hole in the clip. Press so that the catches on the inside are pressed together and the upper edge of the panel can be prized off.
Carefully pry off the panel at the front and rear edge. It is secured by a clip at each end.
Remove the panel with the rubber strip.
Unhook the rubber strip from the panel.

IMG-296663

Remove all clips (8 pcs on each side) from the sill, and at the front and rear wing, and replace with new ones.

IMG-287323

Remove the front end of the panel. The end must be reused.
The panel will not be reused.

IMG-287324

Take the front end of the panel and replace the old clips with new ones from the kit.

IMG-287343

Saw off 30 mm (1 3/16" ) from the upper baffle in the front sill panel.
File down the edges.

Installation

IMG-287344

Installation

Take the running board from the kit. Install the front end on the running board.

IMG-287345

Take the clips from the kit and press them onto the running board.

IMG-287346

Press the existing rubber strip onto the running board.

IMG-287347

Take four rivet nuts from the kit and tighten in the drilled holes in the sill. Use tool 9512782.

Note!
Rivet in the upper hole of the two adjacent holes for the rear mounting hole.

IMG-287348

Note!

Two people are needed for the following three steps.

Take the bracket from the kit and install on the sill. Tightening torque 50 Nm (37 lbf.ft.).

IMG-287349

Hang the running board on the attached bracket.
Align the locating pins in the front and rear end.
Align all clips in their holes on top and press securely. Ensure that all nine clips engage.