Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Further information

When installing, the car must retain a temperature of 20 degrees C.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Set the ignition key to position 0.

Removal

Ground connection

Tightening torque: M6 , 10 Nm

Route the cable harness to the existing cable harness.

Accessory installation

Use: 1161721, Isopropanol

Wipe dry.

Use: 1161721, Isopropanol

Wipe dry.

Remove the protective film.

When installing Velcro tape the surface must maintain a temperature of at least +20 ° C (68°F).

Locate the pre-routed connectors.

Connect the connectors.

Remove the protective film.

Place the component where indicated in the graphic.

Place the component where indicated in the graphic.

Detach the panel.

Installation

Download software (application) for the accessory's function according to the service information in VIDA.

Order and download software according to: 31350003

Check

7-pin connection

1. Brake lamp/Left indicator

2. Ground connection

3. Spare slot (brake lamp, electrical trailer brake)

4. Stop lamp/ Right turn signal lamp

5. Charging

6. Position lamp

7. Spare (back-up light)

The wire for pin 3 for7-pin connection is blue (BL)

The cable is secured at the wiring approximately 1 metre from the trailer connector.

4-pin connection

1. Stop lamp/ Right turn signal lamp

2. Brake lamp/Left indicator

3. Position lamp

4. Ground connection

Installation

Reinstall the removed parts in reverse order.