Find a retailer
  • S60
  • S80
  • V40
  • V60
  • V70
  • XC60
  • XC70
  • XC90
  • Other models
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
S60 2013

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
307580771.030756499
Mesh pocket, cargo compartment, side panel




IMG-339771




 
Equipment
A0000162
IMG-239660
IMG-239681
IMG-339772


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 
1
IMG-339778
 

    Mesh pocket right side

  • Apply the strips of tape as illustrated.

  • Make marks for drilling holes for the mesh pocket mountings.

  • Drill out the hole.

2
IMG-339785
 

  • Insert the pocket's rear mounting in the hole in the panel and fold down.

3
IMG-339776
 

  • Insert the mesh pocket's front mounting towards the panel and lower end towards the floor.

4
IMG-339773
 

  • Move the front mounting to one side and drill the hole.

5
IMG-339774
 

  • Insert the front mounting in the panel and fold down the mesh pocket.

6
IMG-339775
 

  • Drill out the holes in the panel through the two clips.

7
IMG-339842
 

  • Tighten the mesh pocket's lower end

8
IMG-339781
 

    Mesh pocket left side

  • Apply the strips of tape as illustrated.

  • Make marks for drilling holes for the mesh pocket mountings.

  • Drill out the hole.

9
IMG-339784
 

  • Insert the rear mounting in the panel and fold down the mesh pocket.

10
IMG-339783
 

  • Insert the mesh pocket's front mounting towards the panel and lower end towards the floor.

  • Mark the hole in the panel level with the middle of the radius of the bent wire frame.

11
IMG-339779
 

  • Move the front mounting to one side and drill the hole.

12
IMG-339782
 

  • Insert the front mounting in the panel and fold down the mesh pocket.

13
IMG-339805
 

Applies to vehicles with control module for electric handbrake.

  • Measure and place the clips in the wire frame. Measure between the rear edge panel and centre.

14
IMG-339804
 

15
IMG-339802
 

  • Remove the clips.

16
IMG-339806
 

  • Lift up the panel and check that the clips are positioned so that the control module and cable harness are not drilled. Move the clips if necessary.

  • Reinstall the panel.

17
IMG-339802
 

18
IMG-339803
 

19
IMG-339775
 

Applies to all models

  • Drill out the holes in the panel through the two clips.

20
IMG-339842
 

  • Tighten the mesh pocket's lower end.

Volvo on:

Your wish list

Guide

Remove from wish list

Go to accessory

Wish list is empty

Bookmark and Share Share

These items will be permanently removed from your wish list. Are you sure??

Empty
Cancel

You have chosen another car. Empty the wish list or cancel to return to the existing wish list.

Empty
Cancel

Change Saved

Item added to wish list